Technoline WS8016 Manual De Instrucciones página 14


Press "ALARM" button can switch the display ALARM1 time or ALARM2 time, in the alarm1 or
alarm2 display mode, press the "UP" button to turn the alarm on or off.

The alarm 1 or alarm 2 turn on, the "
function is open, The repeat of alarm icon at the same time is also displayed.

The alarm 1 or alarm 2 turn off, the"
function is close.
Notes:

The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this
case the alarm will be repeated automatically after 24 hours.

Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst the
alarm signal is heard.
Stop the alarm signal

During the alarm sound, press any button to stop the alarm.
Snooze function:

When the time is up to the alarm, touch "SNOOZE", the alarm signal stops, and enter the
SNOOZE mode. After the snooze time is counted, the alarm will ring again.

In snooze mode, press any button buttons or touch "SNOOZE" and hold for more than 2
seconds to exit the snooze mode.
Notes:

When the snooze function is set to OFF, when the time is up to the alarm, touch the
"SNOOZE" character position does not have this snooze function.
Temperature & Humidity Detection:

Temperature measuring range: -9.9°C (+14°F) ~ +50°C (+122°F), LL °C(°F) will displayed if
value lower than -9.9°C (+14°F), HH °C(°F) will displayed if value higher than +50°C (+122°F).

Humidity measuring range: 20%RH ~ 95%RH, 19%RH will displayed if value lower than
20%RH, 96%RH will displayed if value higher than 95%RH.
°C or °F temperature display

The temperature is displayed either in °C or °F. Briefly pressing the "°C/°F" button allows you
to switch between °C or °F.
Low battery:

When the low voltage icon "
Trouble shooting
If your clock displays irrelevant time or does not function properly, which maybe caused by electro-
static discharge or other interference, slide open the battery cover, take out the batteries and reinstall
them by observing the correct +/- polarity. Your unit will be reset to default settings and you need to
set it again.
Hereby, Technotrade declares that this product WS8016 is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU and ROHS 2011/65/EC. The
original EU declaration of conformity may be found at: www.technoline.de/doc/4029665080161
Environmental reception effects
The clock obtains the accurate time with wireless technology. Same as all wireless devices, the
reception is maybe affected by the following circumstances:

long transmitting distance
" or " "icon is displayed, the alarm 1 or alarm 2
" or " "icon disappears, the alarm 1 or alarm 2
" is displayed, you need to replace the battery.
EN6