Publicidad
Idiomas disponibles
Idiomas disponibles
012724
Screw the side grip securely on the position of the tool as
shown in the figure.
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Installing or removing wheel guard
(For depressed center wheel, multi-disc, wire
wheel brush / abrasive cut-off wheel, diamond
wheel)(Optional accessory)
WARNING:
When using a depressed center wheel, multi-disc
•
or wire wheel brush, the wheel guard must be fitted
on the tool so that the closed side of the guard
always points toward the operator.
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels.
For tool with locking screw type wheel guard
1
2
012733
Mount the wheel guard with the protrusions on the wheel
guard band aligned with the notches on the bearing box.
Then
rotate
the
wheel
counterclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation procedure
in reverse.
1. Wheel guard
2. Bearing box
3. Screw
3
guard
around
180
For tool with clamp lever type wheel guard
009430
Pull the lever in the direction of the arrow after loosening
the screw. Mount the wheel guard with the protrusions on
the wheel guard band aligned with the notches on the
bearing box. Then rotate the wheel guard around 180 ﾟ.
1
009431
Tighten the wheel guard with fastening the screw after
pulling lever in the direction of the arrow. The setting
angle of the wheel guard can be adjusted with the lever.
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
wheel or multi-disc (optional accessory)
WARNING:
When using a depressed center wheel or multi-disc,
•
the wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
ﾟ
012988
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
9
1. Wheel guard
1
2. Bearing box
3. Screw
4. Lever
2
3
4
2
1. Screw
2. Lever
1. Lock nut
1
2. Depressed
2
center wheel
3
3. Inner flange
Publicidad
