Install Wood Mounting Strip - Best WP29M Serie Manual De Instalación

4. REMOVE THE FILTERS AND THE GREASE DRIP RAIL(S)
A. Remove tape on filters.
Remove filters from hood and set aside.
NOTE: It is recommended to start with the center one.
B. Remove tape on grease drip rail (1).
Lift out grease drip rail and set aside.
NOTE: The 60-inch width hood has 2 grease drip rails.
5. REMOVE THE PAN
Using a Phillips no. 2 or Robertson no. 2 screwdriver, remove the screws retaining the
pan (shaded part on illustration at right) to the hood. Remove the pan and set aside.

6. INSTALL WOOD MOUNTING STRIP

Measure and mark a level line on wall above cooktop location for the wood mounting
strip (see illustration at right and under step 2). Remove wood mounting strip from
back of hood.
Use no. 10 - 2'' flat head screws to secure the mounting strip to the drywall. Make sure
to hit the wall studs.
Due to the weight of this hood, ensure that the wood strip is attached
to all of the available studs (2 studs minimum for a 30'' width hood,
more as hood width increases); not into the drywall alone.
CAUTION
HD0175
HD0174A
1. Drywall
2. Wood mounting strip
3. Flat head screw
7
1
R
ETAINING SCREWS LOCATION
HD0536
4. Wall anchor location
5. Back of hood outline
6. Wall studs