Publicidad
Idiomas disponibles
Idiomas disponibles
Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Remove 7" Round Duct Plate from top/back of hood (see illustration below). Keep the screws
3 ] Turn the hood upside down. Grab the front edge of the decorative panel and lift it to detach
4 ] Using a 11/32" nutdriver or socket, remove both lock nuts retaining the flange of the cover plate
10
for further use.
2 SCREWS
the panel from the front magnets (A). Remove the decorative panel from the hood by tilting it
slightly to disengage it from 3 hooks (B), then set aside the panel.
A
MAGNETS
to the inner back of hood (see insets). Remove the cover plate retaining screws (10 screws),
then set the blowers cover along with its screws and nuts aside.
B
5
4
6
9
7
10
8
8
LOCK NUTS
7" ROUND
DUCT
PLATE
3
2
1
BACK OF HOOD
1
Publicidad
