Pioneer PDK-TS15U Manual De Instrucciones página 3

Checking the Standard Accessories
Check to make sure that you have all the standard accessories before assembly and installation.
• Note that a Phillips screwdriver (not included) is required for assembly.
Base cover x 1
Screws
(M5 x 10 mm: silver) x 6
Assembling the Stand
Assembly Procedure
1
Turn the base cover over so the underside
is facing up.
2
Insert the stand pipes into the base cover.
3
Tighten the screws to stabilize the stand
pipes.
Note
Assemble the stand with a soft sheet placed under the base
cover.
If a sheet is not laid before assembly, the front surface of the
base cover may be scratched.
Stand pipes
(left and right, interchangeable) x 2
Installation bolts
(M6 x 20 mm: black) x 4
Base cover
Cable clamps x 2
Operating instructions
(this document) x 1
Table top stand
Pied de table
Soporte de mesa
PDK-TS15U
Operating instructions
Mode d'emploi
Manual de instrucciones
Screws
(M5 x 10 mm: silver)
Stand pipe
Screws
(M5 x 10 mm: silver)
Sheet
Stand pipe
3
En