Publicidad
Idiomas disponibles
Idiomas disponibles
Before
starting
CAUTION:
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove 1 of 3 screws from the posts of
the glass frame assembly and keep it for future
use. Loosen the other 2 screws. (Do not remove)
Step 2. While holding the light kit under your
fan, make the polarized plug connections: (Fig.
16)
- White to white
- Blue to black
Step 3. Place the key holes in the light kit over
the two screws previously loosened from the
glass frame assembly. Turn the light kit until the
light kit locks in place at the narrow section of
the key holes. (Fig. 16)
Step 4. Securely tighten the two mounting screws
previously loosened and the one previously
removed.
Step 5. Raise glass shade up against the light kit
and secure it to fan by turning glass clockwise
until snug. DO NOT OVERTIGHTEN. (Fig. 17)
Step 6. Install 2 x 7W LED bulbs (included).
9.
Installing the Light Kit and Glass Shade
installation,
Wire connectors
Light kit
Figure 16
Glass frame
assembly
Bulbs
Screws
Figure 17
Light kit
Glass
shade
Publicidad
