Publicidad
Idiomas disponibles
Idiomas disponibles
PAGE 2 OF 12
ASSEMBLY
LEG ASSEMBLY
1. Attach square bracket to underside of desk using
4 standard bolts and nuts. (See Figure 1)
Figure 1
2. Flip desk over on a smooth, non-marring surface
with the top side facing down.
3. Attach legs to square bracket using 4 standard bolts
and 4 nuts on each leg. (See Figure 2)
NOTE: Make sure all 4 leg holes are lined
up with the square bracket holes before
assembling.
Figure 2
4. Attach adjustable feet to inside of legs at desired
height. Only insert bolts in 3 of 4 holes, leaving the
bottom hole on the sides open. Use 3 standard bolts
and 3 nuts for each foot. (See Figure 3)
NOTE: Do not tighten bolts completely
until instructed.
Figure 3
1022 IH-4158
Publicidad
