Descargar Imprimir esta página

Campbell Hausfeld WL6700 Serie Manual De Instrucciones página 10

Ocultar thumbs Ver también para WL6700 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions and Parts Manual
Assembly
tooLS requIreD For ASSeMbLy
Ratchet with 3/8 inch Socket
u
(2) Wrenches
u
hAnDLe ASSeMbLy
1. Slide handle into shroud holes,
making sure handle is on the outside
of the bracket and the holes of the
handle line up with the holes of the
tank bracket.
2. Insert screws through handle and then
the bracket. Using a ratchet with 3/8
inch socket, tighten screws to hold the
handle in place.
InFLAtIon hoSe ASSeMbLy
1. Apply thread tape to both ends of the
recoil hose to prevent leaks.
2. Thread the coil hose into the fitting on
the shroud. Use 2 adjustable wrenches
to tighten the connection by holding
the bottom wrench steady and
tightening with the top wrench (See
Figure 10).
3. Screw blow gun onto the end of the
coil hose. Use 2 adjustable wrenches
to tighten the connection by holding
the bottom wrench steady and
tightening with the top wrench.
Once the recoil hose and blow gun are
attached, make sure no pressure is in
tank before replacing. Recoil hose and
blow gun must be installed for unit to
operate properly.
10
www.chpower.com
All manuals and user guides at all-guides.com
Figure 9 - handle assembly
Figure 10 - Inflation hose assembly
Apply thread tape to both
ends of the recoil hose to
prevent leaks

Publicidad

loading

Este manual también es adecuado para:

Wl6700