Publicidad

Enlaces rápidos

Operating Instructions
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the
product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could
result in personal injury and/or property damage! Retain instructions for future reference.
BUILT TO LAST
Description
Oilless compressors are designed for
do-it-yourselfers with a variety of home
and automotive jobs. These
compressors power spray guns, impact
wrenches and other tools. These units
operate without oil.
Safety Guidelines
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information,
observe the following symbols.
Danger indicates
DANGER
!
an imminently
hazardous situation which, if not
avoided, WILL result in death or serious
injury.
Warning indicates
WARNING
!
a potentially
hazardous situation which, if not
avoided, COULD result in death or
serious injury.
Caution indicates a
CAUTION
!
potentially
hazardous situation which, if not
avoided, MAY result in minor or
moderate injury.
Notice indicates
NOTICE
important
information, that if not followed, MAY
cause damage to equipment.
Unpacking
After unpacking the unit, inspect
carefully for any damage that may have
occurred during transit. Make sure to
tighten fittings, bolts, etc., before
putting unit into service. In case of
questions, damaged or missing parts,
please call 1-800-543-6400 for customer
© 2000 Campbell Hausfeld
Oilless
Compressors
TM
DO NOT RETURN THE
PRODUCT TO THE
STOP!
RETAILER!
Record the Model No., Serial No. and
date of purchase located on the base
below the pump in the space below.
Model No. ____________________
Serial No. ____________________
Date of purchase _________________
Retain these numbers for future
reference.
assistance or call the nearest Campbell
Hausfeld Authorized Service Center.
A listing of service center locations is
enclosed. Have the serial number,
model number, and parts list (with
missing parts circled before calling.
Do not operate
WARNING
!
unit if damaged
during shipping, handling or use.
Damage may result in bursting and
cause injury or property damage.
General Safety
Information
Since the air compressor and other
components (material pump, spray
guns, filters, lubricators, hoses, etc.)
used, make up a high pressure
pumping system, the following safety
For parts, product & service information
visit www.chpower.com
WL Series
DANGER
!
Breathable Air Warning
This compressor/pump is not
equipped and should not be used
"as is" to supply breathing quality
air. For any application of air for
human consumption, the air
compressor/pump will need to be
fitted with suitable in-line safety
and alarm equipment. This
additional equipment is necessary
to properly filter and purify the air
to meet minimal specifications for
Grade D breathing as described in
Compressed Gas Association
Commodity Specification G 7.1 -
1966, OSHA 29 CFR 1910. 134,
and/or Canadian Standards
Associations (CSA).
DISCLAIMER OF WARRANTIES
In the event the compressor is used
for the purpose of breathing air
application and proper in-line
safety and alarm equipment is not
simultaneously used, existing
warranties shall be voided, and
Campbell Hausfeld disclaims any
liability whatsoever for any loss,
personal injury or damage.
precautions must be observed at all
times:
1. Read all manuals
included with this
product carefully. Be
thoroughly familiar
with the controls and
the proper use of the equipment.
2. Follow all local electrical and safety
codes as well as in the US, National
Electrical Codes (NEC) and Occupational
Safety and Health Act (OSHA).
IN203203AV 11/00
Need
Assistance?
Call Us First!
1-800-543-8622
MANUAL

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Campbell Hausfeld WL Serie

  • Página 1 Caution indicates a warranties shall be voided, and CAUTION A listing of service center locations is potentially Campbell Hausfeld disclaims any enclosed. Have the serial number, hazardous situation which, if not liability whatsoever for any loss, model number, and parts list (with avoided, MAY result in minor or personal injury or damage.
  • Página 2: Wheel Assembly

    Oilless Compressors Welding, drilling or any other 2. Place a short piece of wood against General Safety modification will weaken the tank end of handle and tap it with a Information (Continued) resulting in damage from rupture or mallet or hammer to drive handle explosion.
  • Página 3 WL Series Assembly grounding plug. Plug must be plugged are connected to the same branch (Con't) into an outlet that is properly installed circuit. and grounded in accordance with all Repeat on the opposite side. b. Voltage supply is normal. local codes and ordinances.
  • Página 4 Oilless Compressors Operation Discharge Tube (Continued) Check Valve (Opposite Side) (Opposite Side) from tank(s) by opening the drain Pressure petcock located underneath the tank. Switch LUBRICATION Regulator This is an oilless product and DOES NOT require lubrication to operate. Handle Air Hose BREAK-IN PROCEDURE Attachment...
  • Página 5 WL Series Operation If thermal overload protector shuts (Continued) motor OFF frequently, look for the TANK PRESSURE GAUGE following causes. Gauge shows pressure in tank 1. Low voltage. Figure 8 indicating compressor is building 2. Clogged air filter. pressure properly. 3.
  • Página 6: Troubleshooting Chart

    Oilless Compressors Troubleshooting Chart Symptom Possible Cause(s) Corrective Action 1. Plugged in? Check fuse/breaker or motor overload Compressor will not run 1. No electrical power 2. Blown fuse 2. Replace blown fuse 3. Breaker open 3. Reset, determine cause of problem 4.
  • Página 7 WL Series Troubleshooting Chart (Continued) Symptom Possible Cause(s) Corrective Action Tank pressure drops 1. Loose connections (fittings, tubing, 1. Check all connections with soap and water solution when compressor shuts etc.) and tighten 2. Loose drain cock 2. Tighten 3. Check valve leaking 3.
  • Página 8 2. WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030, Telephone: (800) 543-6400 3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of resale) of the Campbell Hausfeld compressor.
  • Página 9 Puisque le compresseur d’air et les autres Codes (NEC) and Occupational Safety en service. En cas de dommage ou de pièces détachées (pompe, pistolets, filtres, and Health Act (OSHA) des É-U. IN203203AV 11/00 © 2000 Campbell Hausfeld...
  • Página 10: Précautions De Pulvérisation

    Compresseur Sans Huile Généralités Sur La Tenir la soupape de sûreté libre de Assemblage peinture et d’autres accumulations. Sécurité (Suite) L’encoche sur le haut de la poignée du DANGER compresseur fournit un endroit 3. Seules les personnes bien familiarisées Ne jamais essayer de réparer avec ces règles d’utilisation doivent convenable pour accrocher un pistolet ou de modifier un réservoir! Le...
  • Página 11 Series WL INSTRUCTIONS DE MISE À LA TERRE Assemblage un électricien qualifié pour l’installation (Suite) d’une nouvelle prise de courant. 1. Ce produit est conçu pour l’utilisation d’un circuit de 120 volts et a une fiche diamètre de 25,40 cm, passer le INSTALLATION DE FILS de mise à...
  • Página 12: Lubrification

    Compresseur Sans Huile Tuyau de décharge (Sens opposé) Fonctionnement (Suite) Clapet Poignée (Sens opposé) Soupape de Sûreté ASME - Cette soupape laisse échapper l’air si la pression Manostat Régulateur du réservoir dépasse la pression maximum réglée d’avance. Tuyau de décharge - Ce tuyau transporte l’air comprimé...

Tabla de contenido