Sony Trinitron CPD-E100E Manual De Instrucciones página 13

Technical Features
Preset and user modes
When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
monitor's memory to provide a high quality picture at the center of
the screen. (See Appendix for a list of the factory preset modes.)
For input signals that do not match one of the factory preset modes,
the digital Multiscan technology of this monitor ensures that a
clear picture appears on the screen for any timing in the monitor's
frequency range (horizontal: 30 – 70 kHz, vertical: 48 – 120 Hz).
If the picture is adjusted, the adjustment data is stored as a user
mode and automatically recalled whenever the same input signal
is received.
Note for Windows users
For Windows users, check your video board manual or the utility
program which comes with your graphic board and select the
highest available refresh rate to maximize monitor performance.
Power saving function
This monitor meets the power-saving guidelines set by VESA,
E S
NERGY TAR, and NUTEK. If the monitor is connected to a
computer or video graphics board that is DPMS (Display Power
Management Signaling) compliant, the monitor will automatically
reduce power consumption in three stages as shown below.
Power mode Power consumption
≤ 95 W
normal
operation
≤ 15 W
1 standby
≤ 15 W
2 suspend
(sleep)*
≤ 5 W
3 active off**
(deep sleep)*
power off 0 W
* "Sleep" and "deep sleep" are power saving modes defined by the
Environmental Protection Agency.
** When your computer enters the "active off" mode, the input signal is
cut and NO INPUT SIGNAL appears on the screen. After 20 seconds,
the monitor enters the power saving mode.
Troubleshooting
Before contacting technical support, refer to this section.
If thin line appears on your screen
(damper wire)
The line you are experiencing on your screen is normal for the
Trinitron monitor and is not a malfunction. This is shadow from
the damper wire used to stabilize the aperture grille and is most
noticeable when the screen's background is light (usually white).
The aperture grille is the essential element that makes a Trinitron
picture tube unique by allowing more light to reach the screen,
resulting in a brighter, more detailed picture.
On-screen messages
If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 14.
1 (power)
indicator
green
The input signal condition
green and orange
OUT OF SCAN RANGE
alternate
indicates that the input signal is not supported by the monitor's
green and orange
specifications.
alternate
NO INPUT SIGNAL
indicates that no signal is being input to the monitor.
orange
off
Damper wire
INFORMATION
OUT OF SCAN RANGE
GB
Input signal
condition
13