Publicidad
Idiomas disponibles
Idiomas disponibles
Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115.
Remove Generator From Carton
1.
Set the carton on a rigid flat surface with "This Side
Up" arrows pointing upward.
2.
Carefully open the top flaps of the shipping carton.
3.
Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
4.
Remove all packing material, carton fillers, etc.
5.
Remove the generator from the shipping carton.
Carton Contents
Check all contents against those listed below:
• Main unit
Figure 1 — Install Wheel Kit
BSPP Generator
Axle
Wheel
E-Ring
6
www.mymowerparts.com
• Engine oil
• Owner's manual
• Engine manual
• Battery charge cables
• Battery charger
• Locking 120/240V, 30A plug
• Locking 120V, 30A plug
• Wheel kit
If any parts are missing or damaged, call the generator
helpline at 1-800-743-4115.
Install Wheel Kit
The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need a socket wrench with 1/2" or 13mm sockets
and a needle-nose plier to install this kit.
Refer to Figure 1 and install the wheel kit as
follows:
1.
Place generator on a hard flat surface.
1/4-20
Lock Nut
Flat
Washer
Vibration
Mount
1/4-20x1" Capscrew
Support Leg
M8 Lock Washer
M8 X 20mm Capscrew
Publicidad
