Publicidad
Idiomas disponibles
Idiomas disponibles
Washer
Dish
Washer
Nut
End Body
Outlet
End Body
O-Ring
Hose
8. Handle Valve Installation
Remove and save the dished washer and nut from the end
bodies.
Install a flexible hose to each valve body outlet. Tighten securely,
but do not overtighten.
Apply a bead of plumbers putty or other sealant to the underside
of the escutcheons according to the putty manufacturer's
instructions.
NOTE: The end body marked "COLD" with blue lettered tape
attached to the tube should be installed to the right of the faucet.
Insert the end bodies into the proper mounting holes.
From the underside of the bidet, slide a dish washer, washer, and
nut onto each end body.
Rotate each end body until the copper tubing faces toward the
outside of the bidet and the outlets face each other.
Firmly hold the end bodies in place and then securely tighten the
nuts with a wrench. Do not overtighten.
Remove any excess putty or sealant.
1009770-2-B
Escutcheon
Apply
Plumbers
Putty.
End Body
Washer
10
Dish
Washer
Nut
Kohler Co.
Publicidad
