Handle
Plastic Nut
Flat Washer
Escutcheon
Sealing Washer
Spline Insert
Valve Stem
Transfer Valve
Plastic Nut
10. Complete Valve/Breaker Installation
From the underside of the bidet, insert the transfer valve into the
mounting hole.
From the front of the bidet, rotate the transfer valve until the pipe
fitting faces toward the right.
From the top of the bidet, slide a sealing washer (tapered side
down), flat washer, and plastic nut onto the transfer valve.
Securely hand tighten the plastic nut.
From the front of the bidet, rotate the valve stem
counterclockwise. Slide the spline insert onto the valve stem.
Thread the escutcheon onto the plastic nut.
Rotate the handle until the pointer faces the front of the bidet.
Press the handle onto the spline insert.
1009770-2-B
12
Kohler Co.