Tripp-Lite SR42UBCL Manual Del Propietário página 9

5. Enclosure Configuration
2 Tilt the top of the panel away from the enclosure.
3 Lift the panel away from the brace that supports it.
5.4.2 Reinstalling Side Panels
To Reinstall Side Panels, Reverse Steps 1-3
5.5 Combining (Baying) Enclosures
WARNING: Combining enclosures is not a substitute for stabilizing the enclosures. Each enclosure in a bay of combined enclosures requires
the same stabilizing measures as a standalone enclosure.
1 Arrange the enclosures in the correct position for baying.
2 Each enclosure includes 4 baying brackets
on the adjoining enclosure. The baying connection points already contain screws. Remove the
screw from each baying connection point in the adjoining enclosure.
3 Loosen the screw in each baying bracket and turn each bracket 90 degrees toward the
adjoining enclosure, aligning each bracket with the corresponding baying connection point on
the adjoining enclosure.
A that correspond to baying connection points
9
2
3
1
B
B
2
3
A
90°