Tripp-Lite SmartPro SMX1000RT2U Manual Del Propietário página 6

Quick Installation
Insert a user-supplied power
1
cord (with country-specific
plug) into the UPS Systems
IEC inlet connection. Plug the
other end into your country-
specific wall outlet.*
NOTE! After you plug the UPS into a live
AC outlet, the UPS (in "Standby Mode")
will automatically charge its batteries,
but will not supply power to its outlets
until it is turned ON.
* See the UPS systems nameplate for input
requirements. Additional input cords are also
available from Tripp Lite.
Plug your equipment into
2
the UPS.*
Additional C13-to-C14 interconnection
cord(s) are included to connect your
equipment to the UPS.
NOTE: Additional interconnection cords are
available from Tripp Lite.
* Your UPS is designed to support only electronic
equipment. You will overload the UPS if the total
VA ratings for all the equipment you connect
exceeds the UPS's Output Capacity. To find your
equipment's VA ratings, look on their
nameplates. If the equipment is listed in amps,
multiply the number of amps by 230 to
determine VA. (Example: 1 amp × 230 = 230
VA). If you are unsure if you have overloaded
the UPS's outlets, see LOAD icon description in
LCD Interface section under Basic Operation.
Turn the UPS ON.
3
Press and hold the
second. The alarm will beep once briefly.
Note: UPS system will function properly upon
initial startup, however, maximum runtime and a
successful self-test will only be accessible after it
has been charged for 24 hours.
20-10-127- 933184.indb 6 20-10-127- 933184.indb 6
button for one
A
6
1
2
A
3
10/16/2020 11:04:31 AM 10/16/2020 11:04:31 AM