Aerofeed 5 Wire Feeder - Solter aeroprocess 2000 Manual De Instrucciones

AEROFEED 5 WIRE FEEDER

TECHNICAL SPECIFICATIONS
GENERAL DESCRIPTIONS
The wire feed unit is the device that makes wire pass through the contact tube of the gun to be melted in the arc. The
MIG-MAG machines have a system for varying the wire feed speed and a magnetic valve for the passage of gas.
A motor transmits power to the drive rollers to move the wire from the coil to the contact tip of the torch. The rollers in
contact are usually a flat one and a bevelled one. The bevel is V-shaped for hard materials such as steel, U-shaped for
soft materials such as aluminium and grooved for tubular steels. It is essential selecting the right roller for the wire dia-
meter and the kind of material which is going to be used.
CARRYING HANDLE
Whenever you want to manipulate the Aerofeed unit, use the carrying handle. This handle must be used if you want
to hang up the winder. The handle of the unit must be electrically insulated from the metal structure of which will be
suspended.
AEROFEED WHEELS KIT
To mount the wheels kit (56206), first remove the 4 nylon feet from the bottom of the unit. Attach the wheels to the 2
brackets and screw these to the base of the winder. Do not reuse the nylon feet to screw the brackets, use the metal
screws provided with the kit.
SOLTER
SOLDADURA S.L.
TECHNICAL SPECIFICATIONS
Input voltage (U1)
Maximum output current
Suitable diameter wires
Wire feed maximum speed
Duty Cycle
IP Protection class
Weight
Nº
1
2
3
4
5
6
7
8
9
AEROPROCESS
AEROFEED 5
24V DC
500A DC
De 0,6 a 1,2mm
18m/min
60%
IP23C
15Kg
Description
Control panel
Pressure regulators of the rollers
Euroconnector
Drive motor
Drive rollers
Wire guide
Wire coil attachment and brake
Wire coil
Carrying handle
18