General Descriptions - Solter aeroprocess 2000 Manual De Instrucciones

GENERAL DESCRIPTIONS

Aeroprocess welding machines have been developed to support MMA, TIG and MIG-MAG welding processes; with a
notable capacity for MIG-MAG welding with multiple combinations of materials and shielding gases.
The range of Aeroprocess machines is equipped with dual digital signal processor, monitoring the status of the wel-
ding arc up to 10000 times per second. Thanks to this technology, the equipment can ensure an accurate and relia-
ble arc under all operating conditions. It can be applied universally to any type of welding of various materials such
as stainless steels, alloy steels, aluminium alloys or other copper or titanium alloys.
The range of Solter Aeroprocess equipments allows rapid setting with the assistance of synergic configuration of
MIG-MAG parameters.
For MMA welding, the machine is equipped with adjustable anti-stick, hot-start and arc-force features. Thanks to
these features, you can weld effectively with any type of coated electrodes.
For TIG welding, the equipment allows Lift Arc ignition, pre and post gas timing, and end current ramp control.
For MIG-MAG welding, the equipment has 28 pre-set synergic programs. In addition, there are also available the
special features of Burn Back, Hot Start, Crater Filling and timing for spot welding.
On the back of the machine, there is a nameplate of the welding machine parameters. This plate is designed in ac-
cordance with the EN 60974-1 Standard.
MEANING OF THE INDICATIONS ON THE SPECIFICATIONS PLATE
EN 60974
S/N....
MMA
TIG
Uo
X
I2
U2
U1
50/60 Hz
IP21
S
SOLTER
SOLDADURA S.L.
International Standard for welding equipment.
Serial number.
MMA welding.
TIG welding.
No-load welding voltage.
Duty Cycle %.
Welding current (Amps).
Test voltage for welding current (I2).
Mains voltage.
Frequency of the mains
IP protection class.
Suitable for working in places with increased risks.
AEROPROCESS
EN
3