CASO DESIGN HW 500 Touch Manual De Instrucciones página 31

13.2 Control panel
Press the button for about 3 seconds to unlock. After approximately 10-15 seconds
without operation it locks automatically. Press the button again to unlock the
device.
Set the desired temperature according to 000 (normal temperature water), 45°C,
55°C, 65°C, 75°C, 85°C, 100°C
Set the water volume according to 100ml, 200ml, 300ml, 000 (continuous water
flow)
Start and stop function setting.
13.3 Rating plate
The rating plate with the connection and performance data can be found beneath the device.
14 Operation and Handling
This chapter provides you with important notices with regard to operating the device. Observe
the following notices to avoid dangers and damages.
► Do not leave the appliance unsupervised during operation.
14.1 Before initial use
14.1.1 Preparation of the waterfilter
1. Remove the waterfilter from all packaging. There may be a small residue of black carbon
particles in the bag or on the filter body. This is normal. These particles are harmless and
will be washed off during the preparation process.
2. Soak the filter upright in water for 10 min.
3. Rinse the filter thoroughly under running water.
4. The filter is now ready for use.
Warning
31