CASO DESIGN HW 500 Touch Manual De Instrucciones página 32

► The lifetime of the filter lasts about 4-6 weeks of normal use (filtering of approximately
150 l water in total).
► Store the replacement filter cartridges in a cool location, out of direct sunlight and away
from heat sources.
14.1.2 Preparation of the device
1. Place device without drip tray.
2. Fill the tank up to max marking.
3. Place vessel below the spout which can collect whole content of watertank.
4. Start the device with 000 temperature setting and continuous water flow until ca. 300 ml
water is dispensed.
5. Turn to 100°C temperature setting with continuous water flow and let the device dispense
water.
6. When device shows Lo (watertank is empty), then the process is finished.
7. The device can now be equipped with waterfilter and filled with fresh water.
8. The device is ready for use.
14.2 Use
1. Fill the watertank with water, you can remove the watertank to do this.
2. Place your cup on the removable drip tray, make sure it aligns with the
spout.
3. First press about 3-5 seconds.
4. Press to choose your desired temperature and press
water volume.
5. Press to operate the device. The desired water will flow out continuously from water
spout. Press
stop working at once.
If you want to dispense water again, repeat the steps above.
6.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The appliance has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
Please note
again, when your desired amount of water is dispensed. The device will
Please note
and light up.
to set the
32