Garland GRASS KEEPER 190 W Manual De Instrucciones página 37

For harvest cutting, place the bag at the back of the
machine and the mulching plug is not in place.
Mulching cut:
In this configuration, the cut grass will also remain
on the lawn but, unlike the cut with discharge with
collection, the cut grass is crushed into small particles
that are deposited on the lawn, generating an organic
fertilizer that provides nutrients and favors the
maintenance of humidity. . For this configuration, the
bag must not be installed, the mulching plug must be
installed and the rear outlet cover closed
Place the mower in a corner of the grass area to be
cut and set the desired height of cut.
Make sure the blade is not in contact with anything
and start the mower.
Walk across the lawn to the rhythm of the mower.
Do not tilt the machine with the engine running except
in the case that you have to start cutting tall grass,
which is the only case in which you may raise the
front wheels slightly to facilitate entry of the mower to
the work area.
Note: If the grass is very high it will be difficult for
you to start the engine. If the grass is very high, you
should slightly raise the lawnmower's front wheels,
forcibly pushing down with the handle, and start
your lawnmower in this position. Once the engine
has acquired the normal engine speed slowly lower
the mower wheels while the machine starts to cut.
Alternatively, if next to the lawn area there is a flat
surface free of objects and without grass (Earth,
screed, concrete), start the lawnmower in the clear
area and entering the grass area by slightly lifting the
front wheels of the lawnmower.
If the engine's rotation speed goes into excess or
it stops, it means that the grass is too high for the
lawnmower's cutting capacity and forcing this can be
harmful to the machine. In this case, make a first cut
at the machine's maximum height and then a second
cut at the desired height.
7.4. EMPTYING THE CATCHER
Empty the lawnmower's bag as soon as you notice
it is full. You will notice that the bag is full because
the mower will stop picking up the cut grass as well,
leaving many remains on the ground.
Whenever you are going to empty the bag, turn off the
engine and check that the blade has stopped before
removing the bag.
37/136
English