Garland GRASS KEEPER 190 W Manual De Instrucciones página 38

English
1. Lift the lid from the rear exit.
2. Lift the catcher.
3. Remove the catcher back.
4. Empty the catcher.
5. Lift the lid from the rear exit.
6. Place the catcher by hooking the protrusions
on the chassis of the catcher to the recess of the
handlebar attachment.
7.5. RECOMENDATIONS
Always cut the grass when it is dry. Avoid mowing
the lawn when it is wet after having watered or after
having rained.
Cut less than 2 cm of grass at a time. If your lawn is
very high, it is advisable to make successive passes
with the 2 cm cutting height every time. So no it will
force both machine.
Cut your lawn often, at least once a week in spring
and summer.
Do not always make the same route when mowing. It
is best to change your route to avoid the grass being
cut in the same direction.
If you need to move the mower between two lawn
areas always first switch off the mower.
Sharpening the blade: A dull blade requires more
energy. A dull blade also cuts badly and makes the
grass yellow.
To obtain a green and bushy lawn, it is necessary to
frequently cut and aerate it regularly, providing the
necessary manure or fertilizer.
The cutting frequency will depend on growth (May-
June). You will need to cut one or two times a week.
At other times of the year, it will be enough to cut it
only once a week.
7.6. AFTER USE
Once you stop using the machine, disconnect the
battery from the machine.
7.7. BATTERY CHARGE
The supply voltage and current must comply with
the information on the nameplate of the charger.
Before using the battery for the first time charge it for
at least 1 hour for the 4 Ah and 40 min for the 2 Ah
To charge the battery plug the charger into the
network, the led will light red. Place the battery in the
charger, the led will light green and start blinking. The
charger LED will change from flashing green to green
when the battery is fully charged. When the battery is
charged, remove it from the charger. If you leave the
battery in the charger and the charger is charged, the
charger will automatically turn off after 2 hours and
the led will turn green.
If you insert the battery in the charger and the LED
starts flashing red, it means that your battery is
damaged or that the battery does not correspond to
this charger.
Important! If you fully charge your battery,
disconnect it from the charger and reconnect it
without using it, the LED may start flashing red
(broken battery signal) when it detects that the battery
does not accept a charge. In this case the flashing red
LED does not mean that the battery is damaged.
Recharge the battery when you notice that the power
38/136