Dexter 330SHS3.5 Manual De Instrucciones página 158

FR
5. BEFORE PUTTING THE EQUIPMENT INTO OPERATION
ES
PT
Grit
60 or less
IT
80 – 100
EL
120 – 150
180 – 220
PL
240 or more
RU
Attaching sanding paper
KZ
Always ensure that the machine is switched o and plug is removed from the
power point before making any adjustment.
UA
1. Select the required grade of sanding paper.
RO
2. Remove any dust or debris from the hook and loop of the base.
3.
To attach hook & loop type sanding paper simply align the holes in the sanding paper
EN
with the holes in the sanding base and press rmly into place.
4.
To remove the sanding paper, peel it away from the base.
5. Ordinary (non Hook & Loop type) sanding paper can also be used.
6. Release the sandpaper clamp from both sides of the sander.
7. Insert the end of the sandpaper under one clamp and pull the paper tight over the base
ensuring the holes align with those in the base and then clamp the other side.
8. The sanding paper should be kept tightly clamped over the base, otherwise there could
be excessive wear of the base material.
WARNING: Do not continue to use the sander with a sanding paper
that is overworn or damaged.
WARNING: Do not use the same sanding paper for wood and metal.
Metal particles become embedded in the sanding paper and will
scour a wooden surface.
WARNING: Take care to regularly clean out the build up of dust on the
base underneath the sanding paper and not to let the sanding paper
wear completely down before replacing it. Failure to observe these two
precautionary measures can lead to damage to the hooks and loops on the
base and the sanding paper will not attach properly.
158
GRIT CHART
Type Example of use
Material removal, heavy paint removal,
Very Coarse
shaping wood
Paint removal, rough surface preparation
Coarse
(e.g. non-planed wood)
Medium Surface preparation planed wood
Sanding between coats
Fine
Very Fine
Final finishing