GreenWorks BL24L00 Manual Del Operador página 6

10.2 INSTALL THE TUBE
1. Move the tube until the lock button (6) engages into the
slot (7).
2. Connect the nozzle to the tube until the latch on the tube
engages into the opening on the nozzle.
You can use the nozzle to increase airflow in tight areas.
10.3 INSTALL THE BATTERY PACK
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
10.4 REMOVE THE BATTERY PACK
1. Push and hold the battery release button (9).
2. Remove the battery pack from the machine.
11 OPERATION
WARNING
Make sure the blower tube is in position before operation.
English
TIP
11.1 START THE MACHINE
1. Pull the trigger (1) to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
11.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
Wait until the motor stops after you stop the machine.
11.3 CRUISE CONTROL LEVER
1. Push the cruise control lever (3) clockwise to increase the
speed. This will lock the speed at the desired setting.
2. Pull the cruise control lever counter clockwise to decrease
the speed.
If you decrease the speed all the way, the unit will stop and
it is necessary to start the machine again.
11.4 TURBO BUTTON
1. Push the turbo button (2), the machine is at the highest
speed.
2. Release the turbo button (2), the machine is at the normal
speed.
11.5 OPERATION TIPS
• Blow around the outer edge of the unwanted materials to
prevent the unwanted materials from scattering.
• Use rakes and brooms to clear the unwanted material
before you blow.
• Make the surfaces wet before you clear the unwanted
material in dusty conditions.
7
NOTE
NOTE
EN