Seca 274 Manual De Instrucciones página 65

Activate automatic
transmission (ASend)
11. Switch on the device you wish to integrate in the
wireless group, e.g. a wireless printer.
A beep can be heard when the wireless printer is
detected.
NOTE
As soon as you have integrated a wireless
printer in the wireless group, you must then
select a print option (menu\rf\APrt) and set the
time (menu\rf\time).
12. Repeat step 11. for all devices you wish to integrate
in this wireless group.
13. Press the Enter key to end the search.
14. Press an arrow key to see which devices have been
detected (here: Mo 3 for a wireless printer).
If you have integrated several devices in the
wireless group, press the arrow key several times to
ensure that all devices have been detected by the
length measuring device.
15. Press the Enter key to leave the menu or wait until
you leave the menu automatically.
You can configure the device so that the measured
results are automatically transmitted to all receivers that
are ready to receive and logged into the same wireless
group (e.g.: wireless printer, PC with USB wireless
module), as soon as the (hold/zero) key is briefly
pressed.
NOTE
If you are using a wireless printer, ensure that
the print option is not switched to "off" (see
"Select print option (APrt)" on page 66).
1. Switch the device on.
2. Select the "ASend" menu item from the "rf"
submenu and confirm your selection.
3. Select "on" and confirm your selection.
You will leave the menu automatically.
The seca 360° wireless network • 65
English