Qlima SRE 23 C-2 Instrucciones De Uso página 73

THE INFORMATION DISPLAY
The information display  not only serves as an indicator of the (set) time and
temperature (sections C, E, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
Code Information
The heater has been automa-
Time
tically turned off by a power
----
cut or bad connection.
An earthquake (magnitude 5
or more), strong vibrations or
a shock will ensure that the
E01
heater automatically
turns off. (The safety system
against shocks has worked).
The heater has been automa-
tically turned off after a fault
E02 or during ignition or due to
E03 the presence of water or dust
in the fuel filter or in the
fixed tank.
An increase in ambient
temperature has turned the
E07 heater off. (The tempera-
ture monitoring system has
worked).
The heater has been automa-
tically turned off because the
hot air stream, the ventila-
Filter tor or the ventilator filter
E09 is blocked or hindered by
something. (The safety system
against overheating has
worked).
The heater has been turned
off in a closed space. (The
E13 safety system against incom-
plete combustion has wor-
ked).
The heater has been turned
off due to an increased CO2
E17 concentration. (The system
for air quality monitoring has
worked).
The heater has automatically
The ON indica-
stopped because the ON / OFF
tor flashes. Err
button was kept pressed in or
lights up
was blocked.
Poor functioning. Heater
F00 – F30
needs maintenance
Action
Restore power or restore the
connection. Press the ON /
OFF key again.
20
Make sure there are no com-
bustible materials around the
heater, or fuel leakages. Press
the ON / OFF key again.
20
Remove the water and the
dust in the fixed tank. Clean
the fuel filter (see chapter M).
Press the ON / OFF button
again.
Ventilate the space. Let the
heater cool off. Press the ON /
OFF button again.
20
Remove obstacles from the
ventilator opening. Clean the
ventilator filter (see chapter
M) Press the ON/OFF but-
ton again. If the problem
20
occurs again after taking the
above measures, contact your
dealer.
Ventilate the space and press
the ON / OFF button again.
20
Ensure the space is sufficien-
tly ventilated.
Ventilate the space and set
the ON / OFF button again.
20
Ensure the space is sufficien-
tly ventilated.
Remove obstacles aroudn the
buttons of the display panel.
Press the ON/OFF button
again.
Note the messages displayed
and turn the heater off. Con-
tact your dealer.
4
71
20
20