Qlima SRE 23 C-2 Instrucciones De Uso página 75

Idiomas disponibles

Fuel filter

Without the 'SAVE' setting your heater will maintain the set temperature by

approximation as well, by adjusting its heating capacity. 'SAVE' is an economy

setting, which you can use when, for instance, you are not present in the room

or to keep it frost-free.

THE 'OIL' INDICATOR

If the low fuel level indicator lights up in combination with a short tone, then

the fuel tank is empty. The heater will automatically burn at its lowest setting

for a period of about 80 minutes. The fuel tank must be replenished.

E remove the removable tank from the heater and fill it with new fuel (outside

the living space in a safe place) (see chapter B)

If you take no action, the fuel tank will be emptied and the display will indicate

"E 03" (fig. Q). The heater is automatically turned off.

To ignite the heater once more, fill the tank and wait a few minutes.

Then press the ON / OFF button

CHECKING THE AIR QUALITY

If the space is insufficiently ventilated, the indicator E17 will light up and the

heater is automatically turned off. As soon as you hear this signal, ventilate

the space (e.g. by opening a door or a window). As soon as the space has been

ventilated sufficiently, (e.g. by opening a door or a window) the heater can be

ignited by pressing the ON/OFF button

MAINTENANCE

Switch off the heater and let it cool down, before you start any maintenance

work. Also disconnect the plug from the mains. Your heater needs hardly any

maintenance.

Clean the ventilator filter (fig. R).

Clean the fuel filter:

Remove the removable tank 4 from the heater and remove the fuel filter

(Fig. S). Some drops may leak from the filter; keep a cloth at hand.

Remove the dirt by tapping the fuel filter upside-down against a hard surface.

(Never clean it with water!)

Reinstall the fuel filter into the heater.

We recommend that you remove dust and stains from time to time with a damp

cloth, because otherwise these may cause stains that are hard to remove.

Do not use solvents or alcohol to clean the heater: fire hazard.

Clean very dirty components with a light synthetic cleaning agent.