Hotpoint Ariston HGF 9.5S AB X/HA Manual De Instrucciones página 36

GLASS controls
GB
Models with mechanical keypad
HGA 9.5 AM X/HA - HGF 9.5 AM X/HA
HGA 6.5 AM X/HA - HGF 6.5 AM X/HA
T1 T2
T1 Motor reset
Pressing the button while the hood is in operation turns it
OFF.
T2 Speed 1
Pressing the button sets the hood to speed 1.
T3 Speed 2
Pressing the button sets the hood to speed 2.
T4 Speed 3
Pressing the button sets the hood to speed 3.
T5 Lights ON/OFF
Models with soft button keypad
HGF 9.5S AB X/HA - HGA 9.5S AB X/HA
HGA 6.5S AB X/HA
T1 T2
T1 Motor reset
Pressing the button while the hood is in operation turns it
OFF.
T2 Speed 1
Pressing the button sets the hood to speed 1.
T3 Speed 2
Pressing the button sets the hood to speed 2.
T4 Speed 3
Pressing the button sets the hood to speed 3.
T5 Booster
Pressing the button sets the hood to high speed. After 5
minutes, the hood returns to the previous speed; pressing
a speed button (T2, T3 or T4) quits booster mode and sets
the selected speed.
T6 Lights ON/OFF
36
T3 T4 T5
B
T3 T4 T5 T6
Grease/odour filter warnings
The T2 icon flashes to indicate that the grease filter is
saturated, while T3 flashes to indicate that the odour filter
is saturated, and if both are flashing then both filters are
saturated. You must then clean/replace the grease filter (A)
or odour filter (B) or both, accordingly (see "Maintenance
and care").
To reset the filter counter:
Hold down T4 for three seconds while the hood is on.
The warning led flashes three times, then returns to its
normal mode If both filter warnings are active at the same
time, you must reset each separately.
The first sequence resets the grease filter, while the second
sequence resets the odour filter.
Models with soft button keypad and display
HGF 9.8 AD X/HA - HGA 9.8 AD X/HA
HGA 6.8 ADI X/HA - HGF 6.8 AD X/HA
T1 T2 T3
1 Motor ON/OFF
Press the button with the hood off to set speed 1. Pressing
the button while the hood is in operation turns it OFF.
T2 Speed -
Pressing the button returns the hood to the previous speed.
T3 Speed +
Pressing the button returns the hood to the next speed. If
the hood is off, pressing these buttons sets speed 1.
T4 Booster
Pressing this button sets the hood to high speed; the letter
"b" flashes slowly on the display. After 5 minutes, the hood
returns to its previous speed; this can also be done while
booster mode is on by pressing either speed button (T2
or T3).
T5 Timer
Pressing this button delays the hood turning off automatically
by 5 minutes. The timer counts down on the display in
minutes. The timer can only be set for manual speeds, not
for booster mode.
T6 Lights ON/OFF
B
T4 T5 T6