Publicidad
Idiomas disponibles
Idiomas disponibles
Grease/odour filter warnings
The bar at the top left flashes to indicate
that the grease filter is saturated.
The bar at the top right flashes to indicate
that the odour filter is saturated.
If both bars are flashing, then both filters
are saturated.
You must then clean/replace the grease filter (A) or odour
filter (B) or both, accordingly (see "Maintenance and care").
The latter only applies to the filter version.
To reset the filter counter:
Hold down T4 for three seconds while the hood is on.
If both filter warnings are active at the same time, you must
reset each separately. The first sequence resets the grease
filter, while the second sequence resets the odour filter.
Configuring the hood
To set the operating mode of the hood, hold down T4 for 6
seconds. After a long beep, the type of installation displays:
Ducted
(square at bottom left flashing).
Filter
(square at bottom right flashing).
You can change the type of installation by pressing T4. To
quit configuration mode, press T1 once; this switches the
unit off and saves the last displayed setting.
Maintenance and care
Caution! Before cleaning or servicing the unit,
disconnect it from the mains by pulling the power plug
or disconnecting the main circuit breaker.
First cleaning
• Remove the protective film
• Clean with a damp sponge and a little neutral soap
• Rinse off with a damp cloth
• Dry with a soft cloth; if the hood is stainless steel, dry
along the metal's grain
Periodic cleaning
The hood must be cleaned frequently (at least as often as
you service the grease filter), inside and out. Use a damp
cloth and a neutral liquid detergent with lukewarm water.
Do not use abrasive or corrosive products.
Warning: Failure to observe the hood cleaning and filter
cleaning/replacement instructions can result in fires. Follow
the instructions carefully. The manufacturer is not liable for
any damage to the motor or fires caused by incorrect care
or failure to follow the above instructions.
Servicing the grease filter (A)
A
If washed in a dishwasher, the metal filter may change
colour, but this does not affect its performance.
Servicing the charcoal filter (B)
The charcoal filter retains unpleasant cooking odours.
The filter saturates after a variable time, depending on the
type of cooking and how often the grease filter is cleaned.
The cartridge must be replaced at least once every twenty
months.
This filter can NOT be washed or regenerated
B
B
The grease filter retains the
particles of grease produced
during cooking; it must be
cleaned at least once a month
w i t h a n o n - a g g r e s s i v e
detergent, either by hand or
with a low temperature, short
dishwasher cycle.
To extract the grease filter,
pull the spring loaded handle.
Disassembly: Remove the
activated-carbon filter by
pressing the two front levers
which secure it to the hood.
A s s e m b l y : S e c u r e t h e
activated-carbon filter first in
the back using the hood's
metal tabs and then in the
front by pressing the two
levers.
37
GB
Publicidad
