Descargar Imprimir esta página

SEVERIN KA 9554 Instrucciones De Uso página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
used: even invisible damage may have
adverse effects on the operational safety
of the appliance.
∙ During operation, the coffee maker must
be placed on a level, non-slip surface,
impervious to splashes and stains.
∙ Do not allow the appliance or its power
cord to touch hot surfaces or to come
into contact with any heat sources.
∙ To prevent the danger of hot water or
steam being emitted, always switch off
the coffee maker and allow sufficient
time for the appliance to cool down
before it is opened or any accessories or
attachments are removed.
∙ Do not leave the appliance without
supervision while it is connected to the
mains.
∙ Always remove the plug from the wall
socket
- in case of any malfunction,
- after use, and also
- before cleaning the appliance.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ Do not allow the power cord to hang
free; the cord must be kept well away
from hot parts of the appliance.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Automatic switch-off
To save energy, the appliance (including
the hot-plate) will switch itself off
automatically about 35 minutes after the
brewing cycle is complete.
Before using for the first time
Before making coffee for the first time,
let the appliance go through two or
three filtration cycles using the indicated
maximum amount of cold water, but without
using ground coffee. This should also be
done if the appliance has not been used
for an extended period of time, and after
descaling.
General information
∙ A measuring scale on the water
container and on the glass carafe
facilitates filling the container with the
correct amount of clean water. The left
scale is used for regular-sized cups of
approx.125 ml, while the right scale is
used for smaller cups. Make sure that
the indicated maximum amount of water
is not exceeded.
∙ If several consecutive brewing cycles
are required, switch off the coffee maker
after each cycle and let the appliance
cool down for approx. 5 minutes.
∙ Important note: When filling the
appliance with fresh water shortly after
a brewing cycle is completed, there is
a danger of scalding from hot water
or steam escaping through the water
outlet.
Making coffee
∙ Filling with water:
Open the water container lid, fill the
container with the desired quantity of water
and replace the lid.
∙ Inserting the paper filter:
Open the swing-out filter sideways and
insert a size-4 paper filter into the filter
11

Publicidad

loading

Este manual también es adecuado para:

Ka 4815Ka 4816Ka 4817Ka 4822