UFESA MB3000 STUBBLE Manual De Instrucciones página 16

DESIGN TRIMMER (Fig.6)
Use the design trimmer to create fine lines and contours around your facial style, close to
the skin.
Hold the design trimming head perpendicular to the skin and move the trimming head
upwards or downwards with gentle pressure.
MINI FOIL SHAVER (Fig.7)
Hold the groomer and allow mini foil shaver gently touches your face.
Use short, well-controlled movements to shave around your beard/moustache. Use your
free hand to stretch your skin. This encourages the hair to stand upright, making it easier
to shave.
NOSE AND EAR TRIMMER (Fig.8)
Insert the nose and ear attachment gently into the nostril or ear.
Gently move the groomer in and out of the nostril or ear and at the same time rotate the
groomer.
IMPORTANT: Avoid inserting the cutting unit more than 6mm into your nostril.
CHARGING THE DEVICE
Before using your groomer for the first time, charge for 2-3 hours, and charge 2 hours
regularly. Ensure the product is switched o . The hair trimmer is completely handy to carry
and can be charged anywhere with the USB cable (Fig.12). First insert the plug on the end
of the USB charging cable lead into the unit and then connect the USB charging cable to
the USB interface. This appliance is suitable for 5V DC Max 1A charger, computer and
other power interface, the charging indicator is red when the battery is charging connecting
the USB interface, the charging indicator is green when the battery is full. IMPORTANT:
This product is for cord and cordless use. Your groomer cannot be overcharged. However,
if the product is not going to be used for an extended period time (2-3 months), unplug it
from the mains and store. Fully recharge your hair clipper when you like to use it again.
To preserve the life of your batteries, let them run out every 2 months then recharge for
2-3 hours again.
MAINTENANCE AND CLEANING
Unplug the product when you do not intend to use it for an extended period of time to
prolong its shelf-life. Allow the device to cool down prior to storage. Separate the tool head
from the body and use the cleaning brush (Fig.5) to remove dust from the internal parts.
Apply a drop of oil (Fig.11) on one of the edges of the blades for their maintenance, and
turn on the device for a few seconds to distribute it. This should be done when you notice
a certain amount of di culty during the trimming operation.
Ensure that the device is unplugged prior to cleaning it.
This device may only be cleaned with a damp cloth, and chemical products must never be
used for the same.