Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting
Connecting peripheral equipment
Video recorder
FM
:
EXT1
ANT
VCR
Other equipment
EXT1
Side connections
4
• Insert the radio aerial lead supplied into the FM ANT
FM ANT.
socket located at the bottom of the TV.
• Use the aerial connection lead supplied and connect
:
the
your aerial socket.
If you are using an indoor aerial, reception may be difficult in
certain conditions.You can improve reception by rotating the
aerial. If the reception remains poor, you will need to use an
:
external aerial
• Connect the power lead to the television and the mains
plug into the wall socket (220-240 V/50 Hz).
• Arrange the leads by passing them through the
television stand.
Video recorder (or DVD recorder)
Carry out the connections shown opposite, using a good
quality euroconnector cable.
If your video recorder does not have a euroconnector socket,
the only connection possible is via the aerial cable.You will
therefore need to tune in your video recorder's test signal and
assign it programme number 0 (refer to manual store, p. 6).To
reproduce the video recorder picture, press
Video recorder with decoder
Connect the decoder to the second euroconnector
socket of the video recorder.You will then be able to
record scrambled transmissions.
Satellite receiver, decoder, DVD, games, etc.
Make the connections as shown opposite.
Make the connections as shown opposite.With the
select
EXT2/S-VHS2
*
For a monophonic device, connect the audio signal to the AUDIO
L input.The sound automatically comes out of the left and right
R
Audio
speakers of the set.
in
L
Headphones
Video in
When headphones are connected, the sound on the TV set
S-Video
will be cut.The
level.
The headphone impedance must be between 32 and 600 Ohms.
socket situated at the bottom of the TV to
.
@
#
P
keys are used to adjust the volume
0
.
n
key,
Publicidad
