Kärcher KHB 4-18 Manual Del Usuario página 10

4. Disconnect the device from the water supply.
5. Secure the power switch with the lock.
6. Remove the battery pack (see chapter Removing
the battery pack).
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. Secure the device against slipping and tipping over
when transporting in vehicles.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
 Store the device indoors only.
 Place the device on a flat and level surface.
Care and service
DANGER
Improper cleaning
Short-circuit
Switch off the device and remove the battery pack be-
fore performing any work on the device.
Do not clean the device with a hose or high-pressure
water jet.
ATTENTION
Improper cleaning
Risk of damage.
Do not use any abrasive or aggressive detergents.
The device is maintenance-free.
Cleaning the device
1. Clean the device with a moist cloth.
Clean the sieve in the water connection
ATTENTION
Damaged sieve in the water connection
Damage to the device through contaminated water
Check the sieve for damage before inserting it in the wa-
ter connection.
If necessary, clean the sieve in the water connection.
1. Remove the water connection coupling.
2. Pull the sieve out.
3. Clean the sieve under running water.
4. Insert the sieve into the water connection.
Troubleshooting guide
DANGER
Touching live parts
Electric shock
Switch off the device and remove the battery pack be-
fore performing any work on the device.
Have repair work and work on electrical components
carried out by the authorised customer service only.
You can remedy minor faults using the following over-
view.
If in any doubt, please contact your authorised Custom-
er Service.
Device not running
The battery pack is not sitting properly in the device
1. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
10
The charging state of the battery pack is too low
1. Charge the battery pack.
The battery pack is overheated
1. Remove the battery pack from the device and allow
it to cool down.
2. Do not the place the device and battery pack in di-
rect sunlight.
The battery pack or the charger are defective
1. Replace the battery pack or charger.
Device switches off automatically
Overheating of the device or battery pack
1. Let the device or the battery pack cool down.
Device not building up pressure
The nozzle is dirty
1. Use a needle to remove dirt from the nozzle hole.
2. Rinse the nozzle from the front with water.
The water supply is too low
1. Open the water tap fully.
2. Check the water inlet for an adequate flow rate.
3. Check the fine filter in the water connection.
Device leaking
1. The device leaks a small amount for technical rea-
sons. If the leak is severe, request authorised Cus-
tomer Service.
Technical data
Device performance data
Working voltage of the battery
Protection class
Operating time (max.) at full bat-
tery charge with Battery Power 18/
25 battery pack
Operating pressure
Max. permissible pressure
Water connection
Feed pressure (max.)
Input temperature (max.)
Suction height (max.)
Dimensions and weights
Weight without battery pack
Length x width x height
Determined values in acc. with EN 60335-2-79
Hand-arm vibration value
Uncertainty K
Sound pressure level L
Uncertainty K
pA
Sound power level L
tainty
WA
Subject to technical modifications.
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
English
V
min
MPa
MPa
MPa
°C
m
kg
mm
2
m/s
2
m/s
dB(A)
pA
dB(A)
+ K uncer- dB(A)
WA
Warranty
18
III
14
2,1
2,4
1,0
40
0,5
1,3
292 x
89 x 228
2,2
0,7
70
2
84