Publicidad
Idiomas disponibles
Idiomas disponibles
f Never immerse electrical parts in water or any other
liquid. Wipe the exterior of the sprayer with a damp
cloth for cleaning. Always make sure the sprayer is
unplugged before taking it apart for cleaning.
f Do not expose unit to rain or wet conditions.
f Do not abuse the cord. Never use the cord to carry
the unit or pull the plug from an outlet. Keep cord
away from heat, oil, sharp edges or moving parts.
Replace damaged cords immediately.
CARACTERISTICAS (Fig. A)
1. Motor housing
2. Flow control indicator
3. Release button
4. Filter
5. Filter cover
6. Trigger
7. Material adjustment jnob
8. O-ring
9. Pickup tube
10. Check valve
11. Tip collar
12. Spray nozzle
13. Spray tip
14. Side fill canister
15. Lid
16. 2-
quart mixing bucket
3/4
17. Viscosity cup
18. Cleaning brush
GENERAL SAFETY WARNINGS
Warning!: General. Can cause severe injury or
property damage.
To avoid these risks, take the following preventions:
f Do not aim the gun at, or spray any person, including
self, or animal.
f Do not spray outdoors on windy days.
f Wear protective clothing to keep spray material off
skin and hair.
f Follow all appropriate local, state, and national codes
governing ventilation, fire prevention, and operation.
f Always use appropriate gloves, eye protection and a
respirator or mask when spraying, thinning, mixing,
pouring, or cleaning.
f Do not operate or spray near children. Keep children
away from equipment at all times. Keep sprayer out of
the reach of children.
f Do not overreach or stand on an unstable support.
Keep effective footing and balance at all times.
f Stay alert and watch what you are doing.
f Do not operate the unit when fatigued or under the
influence of drugs or alcohol.
f Read all instructions and safety precautions for
equipment and spray material before operating any
equipment.
f Hearing protection is recommended for extended use.
GROUNDING INSTRUCTIONS
This product must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. This product is equipped with a cord having
a grounding wire with an appropriate grounding plug.
The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local codes
and ordinances.
Warning!: ELECTRIC SHOCK HAZARD.
Improper installation of the grounding plug is
able to result in a risk of electric shock. When
repair or replacement of the cord or plug is
required, do not connect the grounding wire to
either flat blade terminal. The wire with insulation
having an outer surface that is green with or
without yellow stripes is the grounding wire.
Three-Pronged Plug
Grounding Prong
Properly Grounded
Three-Pronged Receptacle
This product is for use on a nominal 120-V circuit and has
a grounding plug similar to the plug illustrated in sketch
A. Only connect the product to an outlet having the same
configuration as the plug. Do not use an adapter with this
product.
Check with a qualified electrician or serviceman when
the grounding instructions are not completely understood,
or when in doubt as to whether the product is properly
grounded. Do not modify the plug provided; if it does not
fit the outlet, have the proper outlet installed by a qualified
electrician.
EXTENSION CORDS
grounding plug and a 3-slot receptacle that will accept the
plug on the product. Make sure your extension cord is in
good condition. When using an extension cord, be sure to
use one heavy enough to carry the current your product
will draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating. If an
extension cord is to be used outdoors, it must be marked
ENGLISH • 21
A
Publicidad
