Publicidad
Idiomas disponibles
Idiomas disponibles
51
Insert the two joined tubes into the air outlet all the way down and repeat the above operation so that the pieces fit
together. Then tighten the screws (or screw) (C) to secure the tube anchorage.
EN
C
ATTENTION: Whenever the blower function is used, the fan cover must remain closed.
VACUUM CLEANER ASSEMBLY
Insert the curved tube through the large opening of the collection bag and pass it through the inside of the bag until it
is pulled out through the hole in the tube. Remove the small part of the tube first and allow the wide part to fit snugly
into the bag. Next, insert the tube with the bag through the air outlet to the bottom and rotate the tube following the
notches until the anchor reaches its stop. Next, tighten the screws (or bolts) to secure the tube anchorage.
Attach the tubes (A) and (B) of the aspirator. Open the fan cover by turning the knob counterclockwise and attach
the two suction tubes together. Again, rotate the tube following the notches until the anchor reaches its stop and is
securely fastened.
A
B
Publicidad
