Drainage - Klarstein 10032463 Manual De Instrucciones

DRAINAGE

When the unit is operating in Cooling or Dehumidify ( DRY) mode, humidity extracted
from the air is collected in an internal tank. If the tank reaches full, the compressor and
motor cut out automatically. At the same time, the "Water Full" indicator comes on. An
alarm will also sound. When the tank is full, carry out the following instructions:
Drain hole
Rubber plug
1. Turn off the air conditioner and avoid moving it when full.
2. Position a container (a water tray for example) underneath the drain hole.
3. Remove the drain knob & rubber plug from the drain hole and allow the water to
drain out.
4. When the container is almost full, replace the rubber plug in the drain hole and
empty the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the drain knob firmly.
7. Switch on the unit - the full water or compressor operating indicator should not be
flashing
Drain knob
EN
37