Water Tank And Continuous Drainage - Klarstein Pure Blizzard Smart 7k Manual Del Usuario

WATER TANK AND CONTINUOUS DRAINAGE

Empty water tank manually
Once the unit shuts down upon full water, turn off the power of the unit and then unplug
the power plug. Move the unit carefully to avoid spillage of water in the water tray at
the bottom of the unit
• Put the vessel that holds water below the water outlet at the back of the unit.
• Screw off the drain cap, unplug the water plug and water will flow into the vessel
that holds water automatically. If the vessel that holds water can not hold all water
in the unit, before the vessel that holds water is full of water, block the water outlet
with the water plug as soon as possible to prevent the water from flowing onto the
ground or carpet.
Note: Protect the drain cap and water plug properly. Tilt the unit slightly backward
when draining. Turn on the unit only after the water plug and drain cap are installed
properly; otherwise, the condensate of the unit will flow onto the ground or carpet.
EN
43