Water Drainage; Maintenance; Trouble Shooting - Klarstein 10017162 Manual Del Usuario

Compressor protection
• Three minutes later after power on / restart, compressor starts to run.
This machine with auto-water-evaporating system. Condensed-water cycle to cool down the
condenser, which will not only improve cooling efficiency, but also save energy.
• If inner water tank is full, "
buzzer shouts , compressor stops and all keys is invalid till machine recovers to be normal.
• Pull out the plug to drain out water, power off the machine and restart it , the machine will runs
normally.
Note: in order to avoid electric shocks, please power-off the machine and pull out plug before
maintenances or repairs.
Cleaning
• Please pull out plug before cleaning .
• Use soft semi-dry cloth to clean the machine. Don't use chemical agents, such as benzene,
alcohol, gasoline and so on ; otherwise the machine surface will be damaged, or even the machine
itself.
• Don't spatter water into the machine .
Filter
• Clean the filters every two weeks, if filters are blocked by dust, machine efficiency will be reduced.
• Clean the filters in warm water with neutral detergent, then dry the cleaned filters on a shady
place.
Note: Don't run the machine without filters.
Season Cleaning
If the machine will be unused for a long time, please do as following:
• Pull out drainage plug to flow out water.
• Let the machine runs under fan mode for 2 hours to dry out the machine internal
• Turn off machine and pull out plug .
• Clean and dry filters , then reinstall them .
• Pull out exhaust pipe for safekeeping .
• Put the machine into plastic bag , and place it on a dry place.
Please contact professional serviceman without delay in following situation
Trouble
Machine cannot work
13

Water Drainage

" will flashed on the screen , machine enter into standby mode,

Maintenance

Trouble Shooting

Cause
Power off
Water-full indicator turns on
Solution
Power on
Drain water out