Publicidad
English
Set the High Temperature Limit Stop
(optional)
Use the included 4 mm Allen wrench to push the
screw cover into the handle. Retrieve the screw
cover when the handle is removed.
Use the 4mm Allen wrench to loosen the handle
screw 4 complete revolutions. Remove the handle.
Remove the flange.
Remove the handle screw from the cartridge stem.
Remove the high temperature limit stop.
Replace the high temperature limit stop so that the
pin on the cartridge is in the desired slot on the
limit stop.
Note: the temperatures given in the diagram
assume a water heater temperature of 140° F,
a cold water temperature of 50°F and a water
pressure of 45 PSI.
Replace the flange. Replace the handle screw.
Use the Allen wrench to turn the screw 4 revolu-
tions.
Replace the handle. Finish tightening the handle
screw. Turn on the water and test the faucet.
Publicidad
