Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Burner grates and components
Turn off all surface burners, and make sure they have all cooled down.
2
1
3
8
7
6
Top
Bottom
40 English
NX7000K_VE_NX58M6850SS_AA_DG68-00909A-02_EN+MES+CFR.indb 40
1.
Remove the burner grates.
Remove the burner caps from the
2.
burner heads.
3.
Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4.
Clean all removable grates and burner
components in warm, soapy water. Do
not use steel-wool pads or abrasive
cleaners.
5.
Rinse and dry grates and burner
components thoroughly.
6.
Return the burner heads to their
positions on top of the manifold
valves. Make sure a starter electrode
is inserted through the hole in each
burner head.
7.
Return the burner caps to their
positions on top of burner heads. To
ensure proper and safe operation, make
sure the burner caps lie flat on top of
the burner heads.
Re-install the burner grates in their
8.
respective positions.
9.
Turn on each burner and check if it
operates properly. After verifying that
a burner operates normally, turn it off.
CAUTION
•
The starter electrodes are not removable. Do not attempt to remove them by
force.
•
Make sure all burner components (heads and caps) are reinstalled properly.
When installed properly, they are stable and rest flat.
•
To avoid chipping, do not bang grates and caps against each other or hard
surfaces such as cast iron cookware.
2017-10-17
3:45:01
Publicidad
