Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
EN
•
Turn the thermostat switch clockwise (to the right)
until it gets to its final position.
•
Summer service (ventilation only): turn the switch
to position
•
Reduced power heating : turn the switch(to the
right) to setting І (1200W).
•
Full power heating : turn the switch (to the right) to
setting ІІ (2400W).
•
Turning-off : turn the switch (to the left) to setting .
Switch
Indicator lamp
Тhermostat
ADJUSTMENT OF THE HEATING CONTROLLER
When the room temperature gets to its desired
condition you should turn the right-hand switch of the
heating controller in counter-clockwise direction to
position in which the appliance turns off but not more
than that. The adjusted that way temperature will be
automatically regulated and kept at a permanent level by
the heating controller.
CLEANING
•
You must first turn off the appliance and disconnect
its plug from the socket. Do not use abrasive
detergents!
•
Clean the body with wet cloth, vacuum cleaner or
a brush!
•
You must never submerge the appliance under
water – there is life danger!
•
If the appliance should not be used for a certain
period of time it must be secured from excessive
dirt and dust by placing it in its original package.
•
You must never place the hot appliance in its
package!
4
Usage and Storage Instructions
WARNING
•
Do not use the appliance next to shower, bath,
shower room, swimming-pool etc.
•
The appliance always should be used in upright
position.
•
Do not use the fan heater for laundry drying. Never
cover the inlet and outlet grating (there is a risk
of overheating). The appliance must be placed at
a distance of minimum 50 cm from furniture and
other objects.
•
The appliance must be placed so that its control
switches are not in the hand-range of persons using
bath or shower.
•
Do not use the appliance in rooms smaller than 4
square meters.
Fan heater has in-built safety device that will turn it off
in case of accidental overheating (for example blocking
of the inlet and outlet grating, slow rotation or no
rotation of the motor).
In order to restart the fan heater, you must disconnect
the plug from the socket for a few minutes (10-30).
Remove the cause for the overheating and then turn the
appliance on again.
Warning: in order to avoid
overheating do not cover the appliance!
Instructions for environment protection
Electric appliances out of use contain valuable
materials and hence must not be disposed in domestic
dumbs ! We kindly ask you for cooperation and active
role in preservation of natural resources by disposing
the appliance to the organized buy-back locations ( if
there are any).
Publicidad
