Bimar VC92 Folleto De Instrucciones página 13

 Before connecting the appliance, check that the voltage values shown on the
data plate correspond to those of the electricity supply network. In the event of
incompatibility between the electric outlet and the plug of the heater, have the
outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the heater. In general, the use of adapters
or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must
not be less that the maximum of the appliance.
 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 Before each use, checkthattheequipmentis in goodcondition, and thatthepower
cable isnotdamaged: if in doubtconsult a qualifiedprofessional.
 Place theappliancefarfrom
Heat sources (e.g.flames, gas stoves etc.)
-
container of liquids (e.g.sinks etc) to avoid any spray or the appliance
-
falling into it (minimum distance of 2 meters)
fabrics (curtains, etc.) or unstable materials that could obstruct the air
-
intake grille; make sure that the front is free of unstable materials (dust,
etc.).
 The surface on which the appliance is placed must be stable, level (otherwise
the unit may fall over) and smooth. Do not place the fan on shelves. Do not hang
the unit on the wall.
 In the event of a breakdown or poor operation, turn the appliance off and have
it checked by professionally qualified personnel; repairs carried out by
unauthorised personnel may be dangerous and invalidate the guarantee.
ASSEMBLY
Attention: always unplug the appliance before you assemble to the fan.
The fan's functions can be controlled either with the keypad located on the
control panel and with the remote control. The remote control must be pointed
at the control panel (max distance 4mt); for the first use take off the tab
transparent plastic of the batteri's side (type AAA), not included inside the box.
Replacing all batteries at the same time is recommended. Do not mix used
batteries with new batteries. Should the remote control not be used for long
periods of time, remove the batteries.
The fan has the following setting and control elements:
- Stand-by-ON button " " (1): To turn the fan on or turn it off in standby mode
13/40