DeWalt DCS388 Manual De Instrucciones página 32

ENglIsh
Fig. D
2
UNLOCKED
Worklight (Fig. A)

CAUTION: Do not stare into worklight. Serious eye
injury could result.
There is a worklight 9 located on the end of the tool near
the shoe. The worklight is activated when the trigger switch
is depressed, and will remain on for a short time after the
trigger switch is released. If the trigger switch remains
depressed, the worklight will remain on.
NoTE: The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Low Battery Indicator
As the battery nears a fully discharged state, the worklight
will blink twice and then dim, dropping the brightness of
the light below the normal level. The light will continue
to blink twice every 45 seconds until the battery is fully
discharged at which time the light will turn off. Indication
time will vary based on battery pack capacity.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Blade Installation and Removal
(Fig. E–G)
Different blade lengths are available. Use the appropriate
blade for the application. The blade should be longer than
3-1/2" (89 mm) and should extend past the shoe and the
thickness of the workpiece during the cut. Do not use jigsaw
blades with this tool.

WARNING: Cut hazard. Blade breakage may occur
if the blade does not extend past the shoe and the
workpiece during the cut (Fig. E). Increased risk of
personal injury, as well as damage to the shoe and
workpiece may result.
30
Fig. E
LOCKED
To Install Blade into Saw
1
1. While holding the blade clamp release lever
(Fig. F), insert blade shank from the front.
2. When the blade is securely in place, release the lever.
Fig. F
NoTE: The blade can be installed in two positions as shown
in Figure G.
Fig. G
To Remove Blade from Saw

1. Open up blade clamp release lever.
2. Remove blade.
OPERATION


Installing and Removing the Battery Pack
(Fig. H)
NoTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
3
CAUTION: Burn hazard. Do not touch the the blade
immediately after use. Contact with the blade may
result in personal injury.
WARNING: Always observe the safety instructions
and applicable regulations.
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
into the tool handle, align the
7
3 up