Makita DSS611 Manual De Instrucciones página 6

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Indicator lamps
5. Check button
6. Lever
7. Stopper
8. Base
9. Cutting line
10. Switch trigger
11. Lock-off lever
12. Shaft lock
13. Hex wrench
SPECIFICATIONS
Blade diameter
Max. Cutting depth
No load speed (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
6
Explanation of general view
14. Tighten
15. Loosen
16. Inner flange
17. Circular saw blade
18. Outer flange
19. Hex bolt
20. Arrow on the tool
21. Arrow on the circular saw blade
22. Ring
23. Dust nozzle
24. Screw
25. Hose
26. Vacuum cleaner
Model
at 90°
at 45°
at 50°
-1
)
Net weight
DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF/DC18SH/DC18WC
DSS610
3.0 - 3.4 kg
BL1815N/BL1820B/BL1830B/BL1840B/BL1850B/BL1860B
Save all warnings and
ENE028-1
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
GEA010-2
Cordless circular saw safety
warnings
Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on
auxiliary handle, or motor housing. If both hands
are holding the saw, they cannot be cut by the blade.
27. Rear handle
28. Front grip
29. Clamping screw
30. Rip fence (Guide rule)
31. Adjusting screw for 45° (DSS610
only)
32. Adjusting screw for 90°
33. Triangular rule
34. Limit mark
35. Brush holder cap
36. Screwdriver
DSS611
165 mm
57 mm
40 mm
36 mm
3,700
347 mm
2.9 - 3.2 kg
D.C. 18V
GEB151-2