Volpi PV400 Manual Del Usuario página 32

•
Connect the cable with pruner tightly:
•
Fasten your belt of the backpack
•
Check the closed position of blade
•
Grip the pruning shear handle part tightly
•
Connect the cable from the right side; please reverse the direction of the batteryfor left-hander
13. Operation start procedure
Please wear suitable cloth and glove when operate this tool. Always check tools before use,
make sure on/off switch and safe switch are all ok. The power should be put off when you
loosen the trigger. Stop using the tool in case of switch failure. Always check rated voltage
of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure blade stop fully before
touch it, otherwise blade will hurt your body.
•
Turn on the power switch. After warning tone, please pull the trigger two times without holding.
And the shear will be on working condition after one more warning tone. Don't overload cutting,
it will protect pruning shear and battery not be damaged. Don't cutting over the dimension
specified in the technical information table.
•
User just loose trigger when the blade has been jammed by branch, the blade will resume
maximum position.
Caution: Don't sway the pruner from the left to right in order not to damage the edge of blade
during the resume process of blade.
Check the working frequency of the blade in order to verify the good working condition.
13.1 Change the open size of blade:
You can adjust the open size of blade from big open size to small open size. Please identify the length
of warning note when press the black button on the shear. If warning note is long, it means the
cutting size is big, if it is short, it means the cutting size is small.
Please see as below: When the open size of blade maintain maximum position, please press the trigger
and maintain 3seconds. Then the blade will keep closed state. When you loose the trigger and press the
trigger 2 times continuously, the open size of blade will be changed into small opening size. If you want
to change the small open size into big size, repeat the procedure above.
When you stop working, please press the trigger and maintain 3 seconds unchanged then the blade will
keep closed state. Then turn off the power switch and pull out the cable from the battery.
32