Volpi PV400 Manual Del Usuario página 33

14. Cutting
Wear suitable work clothes such as boots with non-slip soles, sturdy long trousers, gloves and goggles.
Wear protection gloves
Wear eye protection
Risk of cutting and severe injuries
Warning!
In particular situations of very hard use, the blade and the handle could reach high temperatures. It is
recommended to handle the pruner with care, using protective gloves.
•
When ready to cut, place the blade on the branch to be cut and press the trigger;
•
When operating the tool, keep the other hand and any other part of your body at a minimum
distance of 15cm from the blade;
•
Keep all other people at a minimum distance of 1.5m
•
Blade will be hurt or jammed if cutting bigger branch
•
Don't move the tool during the pruning shear cutting, it can cause danger.
•
Use sleeve to fix the wire of device avoid wire be draw by branch, that's will cause risk in working.
•
Don't use the device in rain or humidity environment.
•
During storage of the device after use, take off wire from battery and pruning, shut up power
switch before storage.
Caution: please check battery charge level or blade sharpening when cutting is difficult or not
smooth.
14.1 Cuttingcontrol mode
The PV400 electric pruning shears has two cutting control modes:
Non-progressive cutting control
•
Progressive cutting control
•
NON-PROGRESSIVE CUTTING CONTROL
When the pruning shear is turned on, the non-progressive cutting control is predetermined,
that is, when the trigger is actuated the blade performs the cutting action, and when the
trigger is released the blade opens.
forcedly.
33