Dimplex Revillusion Sherwood SWD20-EU Manual Del Usuario página 10

Operation
Icon Function
Color
E
Themes
F
360
G
Brightness
H
Flame
Light
I
Sensor
J
Timer
Control Lock
Control Unlock
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn the heater off and it will
not come back on without being reset. It can be reset by disconnecting power at
the main electrical panel and waiting 5 minutes before plugging the unit back in.
CAUTION: If you need to con tinuously reset the heater, unplug the unit and call
technical support.
10
Description
Press multiple times to change the flame base colors
from Red to Blue to Off. (The first segment on the
display will change from "r" to "b" to blank) This
feature is active only when the flame effect is On.
Press multiple times to change the LEDs on the sides
and back of the unit from Midnight mode to white to
Light yellow to red. (The middle segment on the display
o
will change through 0 - 3 respectively. This feature is
active only when the Flame is ON.)
Press to change the LED lights from High to Low.
(The last segment on the display will change from
"H" to "L") The Realog
heater is ON and the flame effect is Off.
!
NOTE: When the Light Sensor is activated, High
and Low flickering brightness settings are also available
(Flashing "H" and "L").
Press to light the log set and start the flame effect.
Press again to turn feature Off.
Press to activate (ALS ON) the ambient light sensor.
Press again to turn the sensor off (ALS OFF).
!
NOTE: The light sensor will adjust the brightness of the
fireplace based on the ambient light in the room.
Press multiple times to change the sleeper timer in
0.5 hr increments from 0.5 hr to 8.0 hr before turning
off. The remaining time on the sleep timer displays.
Hold both Temp– (
unit, for 2 seconds to disable the manual controls.
Hold both Temp– (
unit, for 2 seconds to enable the manual controls.
LEDs remain On when the
TM
) and Brightness (
) and Brightness (
), on the
), on the