FLAEM Smarty Manual De Instrucciones página 13

DO NOT IMMERSE IN
SOLUTIONS BASED ON
CHLORINE
6.4.1 METHOD A: DISINFECTION BY STEAM
6.4.1.a Disinfect the accessories provided in
Table 1 following the disinfection procedure
with device for feeding-bottle (without mi-
crowave), it requires a treatment duration
of at least 15 minutes. It is necessary to use
demineralised or distilled water to prevent
limestone deposits, which could impair the
function of the nebuliser head. Carefully
read the instructions for use of the device
in question, paying special attention to the
amount of needed water and the method
to be followed to carry out the disinfection
phases.
6.4.2 METHOD B: DISINFECTION BY BOILING
6.4.2.a Disinfect the accessories provided in
Table 1 by boiling for 20 minutes; it is neces-
sary to use de mineralized or distilled water
to prevent limestone deposits, which could
impair the function of the nebuliser head.
6.4.2.b DRYING: Before making a new ap-
plication wait until the components have
cooled down and dried.
6.4.3 METHOD C: DISINFECTION BY CHEMICAL
WARNING Except the nebuliser head
2G
6.4.3.a The disinfectant to be used must be an
electrolytic chloroxidizer (active principle:
sodium hypochlorite), specific for disinfect-
ing, which is available in any pharmacy.
6.4.3.b Fill a container, whose size is suitable
to hold all of the accessories to be disinfect-
ed listed in Table 1, with a drinking-water
and disinfectant solution, according to the
proportions indicated on the packaging of
the disinfectant itself.
6.4.3.c Completely immerse each accessory in
the solution, taking care to avoid the forma-
tion of air bubbles that may come in contact
with the accessories. Leave the accessories
immersed for the amount of time indicated
on the packaging of the disinfectant, and
associated with the concentration chosen
to prepare the solution.
6.4.3.d Remove the accessories and rinse
13