Publicidad
Idiomas disponibles
Idiomas disponibles
2. Depress the trigger.
To Operate the Tool Using the Bump Actuation Method
1. Depress the trigger.
2. Push the contact trip against the work surface. As long
as the trigger is depressed, the tool will fire a nail every
time the contact trip is depressed. This allows the user
to drive multiple nails in sequence.
WARNING: Do not keep trigger depressed when tool
is not in use. Keep the trigger lock-off in the locked
position when the tool is not in use.
WARNING: When the tool's motor is running, the
next actuation, pulling the trigger or depressing the
contact trip, will cause a nail to fire.
Speed Selection (Fig. A, H)
This nailer is equipped with a dual speed selection
switch
located on the foot.
13
•
For shorter nails, select speed 1 by setting the switch to
the left most position.
•
For longer nails and more rigorous applications, select
speed 2 by setting the switch to the right most position.
In the event that nails are not driving to depth in speed
setting 1, you may have to switch to speed setting 2 for
additional driving power.
Fig. H
suggested speed settings
Application
Typical nail length
Framing & Decking
3-1/4" (83 mm)
General Framing
3" (77 mm)
Sheathing
2-3/8" (60 mm)
Fencing
2" (50 mm)
Preparing the Tool
NOTICE: NEVER spray or in any other way apply
lubricants or cleaning solvents inside the tool. This
can seriously affect the life and performance of
the tool.
nOTE: The battery pack is not fully charged out of the
carton. Follow instructions outlined (refer to Charging
a Battery).
1. Read the Nailer Safety Warnings section of
this manual.
2. Wear eye and ear protection.
3. Remove battery from tool.
4. Ensure magazine is empty of all fastners.
5. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly. nEVER use
a tool that has the contact trip restrained in the
actuated position.
6. Keep tool pointed away from yourself and others.
7. Insert fully charged battery pack.
Using the Trigger Lock-Off (Fig. I)
WARNING: To reduce the risk of serious personal
injury, do not keep trigger depressed when tool is not
in use. Keep the trigger lock-off switch LOCKED (Fig. I)
when the tool is not in use.
WARNING: To reduce the risk of serious personal
injury, lock off trigger, disconnect battery pack
from tool and remove nails from magazine before
making adjustments.
Each D
WALT nailer is equipped with a trigger lock-off
e
which when pushed to the right as shown in Figure I,
prevents the tool from firing a nail by locking the trigger and
bypassing power to the motor.
Fig. I
13
When the trigger lock-off is pressed to the left, the tool will
be fully operational. The trigger lock-off should always be
locked off (Fig. I) whenever any adjustments are made or
speed setting
when tool is not in immediate use.
2
NOTICE: Do not store tool with battery pack installed.
To prevent damage to the pack and to ensure best
2
battery life, store battery packs out of the tool or
2
charger in a cool, dry location.
1
Loading the Tool (Fig. J)
WARNING: Keep the tool pointed away from yourself
and others.
WARNING: Never load nails with the contact trip or
trigger activated.
WARNING: Always remove battery pack before
loading or unloading nails.
CAUTION: Keep fingers clear of pusher latch track to
prevent injury.
WARNING: The trigger lock-off should always be
engaged whenever any adjustments are made or
when tool is not in use.
1. Turn the nailer upside down.
English
2
2
11
Publicidad
