BWT BC50 Manual De Usuario página 15

TROUBLESHOOTING
Problem
Pool vacuum does not capture the
debris
Debris escapes from the filter
Debris goes outside the filter cone
Handle / pole connector cannot be
secured in assembly
Pool vacuum cannot be charged /
recharged
Pool vacuum is activated even
though the switch indicates it's off.
Operation time is shorter as
expected
Environmental Programmes, WEEE European Directive
Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly
recycles electrical and electronic equipment. Do not dispose them in unsorted waste bins. For items
containing removable batteries, remove batteries before disposing of the product.
© 2021 BWT Holding GmbH.
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any
means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission
of BWT Holding GmbH. (V1)
If soft copy of this instruction manual is required, please contact our customer service by
email.
SAVE THESE INSTRUCTIONS
Possible Cause
Battery is running out
Impeller is jammed
Impeller is broken
Filter is full
Larger debris / large volume
of debris
Suction nozzle flap is
broken
Filter net is damaged
Outlet valve comes off
Side pin is broken
Battery is damaged
Contact plates of the
charger base and unit are
not connected.
External adaptor is out of
order
Presence of magnetic
objects nearby has
inadvertently switched on
the motor.
Battery is not fully charged
Solution
Charge the battery again.
Power off the pool vacuum and visually check the gap
in middle of the pool vacuum to see if the impeller is
jammed by larger debris. If possible, use a small tool to
remove it with intensive care & caution. If necessary,
contact your dealer for further instructions.
WARNING!
Make sure the pool vacuum is
powered off when the unit is being serviced.
Contact your dealer for impeller replacement.
Clean the filter cone if applicable.
Remove the pivoting suction head (not recommended
for SPAs, vinyl liner and fibreglass pools as it could
scratch the spa & pool surface.)
Suction nozzle flap works like a door to prevent the
debris from escaping from the filter. Contact dealer for
replacement parts and instruction.
Replace with a new filter cone.
Without the outlet valve, the pool vacuum might
capture debris through this opening. Contact dealer for
valve replacement.
Replace with a new handle / pole connector.
Contact dealer for battery replacement.
WARNING!
DO NOT open the pool vacuum
and replace the battery by yourself. This could result in
severe or fatal injuries and the warranty will be voided
as a result.
Make sure that the charger base is assembled on the
unit properly so that their contact plates are touching.
Contact dealer for replacement.
WARNING!
Using the wrong external adaptor
will result in damaging the pool vacuum / battery and
voiding the warranty as a result.
Move the magnetic objects or vacuum away from each
other.
Charge the pool vacuum for at least 6 hrs. NOTE: if
any stains are found on the charging contact plates,
remove them by using a cotton bud soaked with lemon
juice or vinegar
21010029
14/175