BWT BC50 Manual De Usuario página 8

Telescopic pole (not included) assembly
Insert the end (with one side pin) of the pole connector into the pool vacuum as shown
until its single side pin is secured to the handle's locking hole on the rear body. Slide the
telescopic pole into the pole connector until the side holes of the telescopic pole are
secured to the side pins of the pole connector.
To release the telescopic pole, press down on the two side pins simultaneously and pull
out the pole.
Specific Telescopic pole (not included) assembly
Insert the end (with two side pins) of the pole connector into the pool vacuum as shown
until its side pins are secured to the handle's locking hole on the rear body. To install the
telescopic pole (with internal wishbone clip) to the pole connector as shown:
Pool Preparation
- If there are stones, roots or metal corrosion in contact with the underside of the liner,
discard them prior to using the pool vacuum. If necessary, seek assistance from a
qualified professional.
- If the liner is brittle, damaged or wrinkled, contact a qualified professional to perform
the necessary repairs or perform a liner replacement prior to using the pool vacuum.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the
pool vacuum into the water.
(only for EU & USA)
(only for Australia & New Zealand)
7/175